CMD P250. Oleo-dynamic churn drill with electrical rotation for marble and stone. It can perform both horizontal and vertical holes (90-250 mm.) in any direction. It does not require any routine maintenance.
Available also in a smaller, lighter and pratical version, CMD P60. (holes  60-150 mm.).
CMD PP90. Hydraulic percussion churn drill, equipped with down-the-hole hammer for granite and hard stones. Special drill wich can perform both horizontal and vertical holes (85-105 mm.) in any direction.
Also available in a lighter and more economical version, CMD PP60, able to make holes up to about 15 meters (90 mm.).
Spares for oleo-dynamic churn drills Tungsten carbide bits "total distruction" (holes 60-90 mm.). Bit support (holes 155-205-255 mm.). Tungsten carbide drills. Tungsten carbide bits for cores (holes 60-90 mm.). Niples (56-60-80 mm.). Drilling rods (length 1,250 /56-60-80 mm.). Spanners for drilling rods, complete range. Turning caps for drilling rods (56-60-80 mm.). Diamond bit for core borings. (Top right of photo).
Spares for pneumatic churn drills Down-the-hole hammers. Drilling rods for down-the-hole hammers. Spanners for rods. Drills for hammers.
Shared spares:
Chains for fixing (length 2,50 m.).
Hooks for chain anchoring (22 mm.).
Drill steels for hooks (22 mm.).
Tie rods.
Slaves.
Drilling rod + down-the-hole bit for churn drill base.
Down jack.
Feathers for cut adjusting.